|
|
I can't find the Uncord™ with my Bluetooth® device
|
|
Make sure that the Uncord™ is properly powered (5VDC and min. 200mA, check polarity).
Make sure that the your Bluetooth® device support SPP (Serial Port Profile).
The Uncord™ must be in discoverable mode (Bluetooth® slave).
|
No data is transmitted over the Bluetooth® link
|
|
Uncord™ is intended to be attached to a DTE-device (e.g. a computer). Please use a proper pin-converter if connecting the Uncord™ to a DCE-device or other RS-232 connector.
Ensure that the Uncord™ is properly configured (baud rate, Stop bits, Parity). Configure the Uncord™ to match the device it is attached to.
Make sure that you have a proper Bluetooth® connection between the F2M01C1 and the other Bluetooth® device.
|
I can't configure my Uncord™
|
|
It is only possible to configure the Uncord™ through the physical serial interface of the device, when there is no active Bluetooth® connection.
If you have a Bluetooth® connection: Detach the power supply, after a few seconds power up the device again and immediately start the configuration program (within a few seconds, before a new Bluetooth® connection is established)
Alternatively: Power down the remote Bluetooth® device to prevent a Bluetooth® connection.
|
My Bluetooth® device require a passkey
|
|
The Uncord™ is by default configured with no passkey. Reconfigure the Uncord™ with a proper passkey.
|
How can I configure the Uncord™ Serial Port Plug from a microcontroller?
|
|
Please read the Wireless UART user manual for a list of all configuration commands.
|
